BMS Engineer —FAT & SAT Support

Open 19d

Designation : BMS Engineer - FAT & SAT Support
Experience : 3 to 5 years

Job Description

Assist in the preparation and execution of FAT/CFAT at the factory or workshop, verifying PLC programming and I/O point functionality against the approved I/O Point Schedule.
Support execution of SAT on-site, verifying installed hardware, wiring, and functional performance of BMS control panels, PLC racks and field devices against the approved System Architecture and PLC Grouping documents.
Verify SCADA graphics, alarms, and point mapping against the approved I/O schedule during testing.
Record test results, punch lists and non-conformances, and support close-out of outstanding testing issues.
Ensure all testing is carried out in accordance with project specifications, requirements, and approved test procedures/protocols.
Assist with test equipment setup (e.g. loop testing devices, multimeters, network testing tools).

Requirements

Knowledge in Electrical, Electronics, Mechatronics, Instrumentation & Control
Prior experience in BMS, PLC and/or SCADA testing and commissioning is preferred.
Familiarity with FAT/SAT procedures and I/O point /control panel verification.
Able to read and interpret wiring diagrams, I/O schedules, and system architecture drawings.
Good communication skills, able to liaise with client and representatives during test witnessing.

See also