CNC Lathe Machinist 3
Posted Updated
Responsibilities
- Start machine to allow it to go through it start up/warm up procedure.
- Load computerized machine control media as needed.
- Selects, aligns, and secures chuck jaws, cutting tools, attachments, accessories, and materials on machine.
- Sets up and operates machine on trial run to verify accuracy of machine settings or programmed control data.
- Obtains and places work piece in machine and removes finished work piece from machine and places it in appropriate temporary storage location.
- Verifies conformance of finished work piece to specifications.
- Start and observe machine operation to detect malfunctions or out-of-tolerance machining, and adjusts machine controls or control media or replaces tools as required.
- Able to perform machine cleaning and minor maintenance and calls supervisor as needed for major maintenance and repair.
- Confers with supervisors, engineers, production personnel, programmers, or others to resolve machining problems.
- Is aware of and helps maintain a safe work area and conditions and makes the safety coordinator aware of any unsafe situations.
Job Requirements
Education and Training
- High School diploma or GED equivalent is preferred.
Experience
- Must have a minimum of two years of experience in this department or equivalent in another department.
- Able to operate different machines and operations within the department including setup and run complex products.
- Able to maintain high efficiency and low nonconformance.
- Able to read and interpret documents such as safety rules, operating and maintenance instructions, procedure manuals and blue prints.
- Able to write routine reports and correspondence.
- Able to add, subtract, multiply and divide in all units of measure, using whole numbers, common fractions and decimals.
- Able to compute rate, ratio and percent.