E and I lead Engineer
To oversees the safe installation, inspection, and verification of electrical and control systems in industrial environments—particularly hazardous areas (such as oil and gas, chemical, or pharmaceutical plants) where explosive atmospheres may be present.
Job Requirement:
1. Hazardous Area(CompEx) Specific Responsibilities
- Inspection & Verification: Conduct detailed and periodic inspections of electrical installations in hazardous areas in compliance with IEC standards and site safety rules.
- Compliance Certification: Ensure all electrical equipment, cable glands, enclosures, and instrumentation located in explosive atmospheres meet CompEx safety standards before energization.
- Defect Management:Identify, document, and track non-compliances or installation defects for hazardous area electrical kits, executing timely corrective actions.
2. Site Construction& Execution
- Subcontractor Supervision: Direct and monitor on-site electrical and instrumentation contractors to ensure compliance with approved drawings, technical specifications, and project schedules.
- Work Pack Review: Review construction work packs, installation drawings, loop diagrams, hook-up schematics, and cable schedules.
- Progress Monitoring: Track daily site progress, compare actual installation rates against project baselines, and identify potential delays or bottlenecks.
3. Quality Assurance& Quality Control (QA/QC)
- Inspection & Test Plans (ITPs): Implement and adhere to site QA/QC procedures and ITPs for cable tray erection, conduit laying, earthing/grounding networks, and field instrument setup.
- As-Built Documentation: Oversee the redlining of drawings and ensure accurate preparation of final "As-Built" documentation for handovers.
4. Testing and Commissioning Support
- Pre-Commissioning Checks: Lead continuity testing, insulation resistance (Megger) testing, loop checks, and calibration of field instruments (pressure, temperature, flow, and level transmitters).
- FAT/SAT Coordination: Participate in Factory Acceptance Testing (FAT) and Site Acceptance Testing (SAT) for control panels, PLCs, and switchgear packages.
Qualification
Must possess diploma or degree in Engineering
Must possess compex certification