Embedded Software Engineer

Key responsibilities

• Establish a reproducible nRF Connect SDK build, programming and debugging workflow with compatible NR+ firmware.
• Bring up a working NR+ link with an appropriate peer and implement the application data path.
• Define the host command/data protocol, framing, flow control, buffering, status reporting and error handling with the BSP and Android engineers.
• Implement configured warm standby, explicit activation/deactivation and positive state confirmation.
• Ensure the standby device does not autonomously resume communication after resets, reconnects or errors.
• Measure activation, association, payload throughput, packet loss and latency under the intended audio/control load.
• Implement watchdog/recovery behavior and diagnostic logging.

Required skills

• Strong embedded C; Zephyr or comparable RTOS development.
• nRF Connect SDK or closely related Nordic development experience.
• CMake, Ninja, west, Zephyr Kconfig/devicetree and GCC-based embedded cross-toolchains.
• UART/SPI peripheral communication, asynchronous events, memory constraints and flow control.
• Wireless protocol debugging and packetized data transport.
• SWD/J-Link debugging and reproducible firmware builds.

Preferred skills

• Direct DECT NR+ or nRF91 experience; candidates with only BLE experience should demonstrate readiness for the NR+ networking work.
• IPv6, UDP, audio packet transport and firmware power-state management.

Expected outcomes

Working NR+ host and peer firmware, a documented host protocol, verified standby behavior, and measured readiness/switching performance.