Fabricator II

Job Summary

The Fabricator II is an experienced-level manufacturing position responsible for independently performing standard fabrication and welding tasks on stainless steel tanks, vessels, and assemblies in accordance with ASME and AWS standards. This role operates semi-independently and is expected to produce quality welds, interpret blueprints without assistance, and contribute to production output without direct supervision on routine tasks. Candidates should have 2–5 years of fabrication experience and hold or be eligible to obtain a basic welding certification (AWS D1.1 or equivalent).

Compensation: $24.00 – $28.00 per hour (rate determined by in-person skills assessment)

Employment Type & Term

JBF Stainless is growing and hiring for a project-based position anticipated to run through approximately June 2026, with the potential to transition into a permanent role for the right candidate. We are transparent about this upfront — some people are looking for project work, and we respect that. Candidates who perform well and where continued work exists may have the opportunity to extend or move into a full-time permanent position. JBF Stainless will provide at least two (2) weeks' notice if a position is ending or not being extended, and we ask the same in return.

Major Responsibilities and Essential Functions

Reasonable accommodations may be made to enable qualified individuals with disabilities to perform the essential functions of this job. See Accommodation section below.

• Independently fabricate and weld stainless steel tanks, vessels, platforms, and structural components to blueprint specifications.
• Perform MIG and intermediate TIG welding on stainless steel; maintain weld quality consistent with AWS D1.1 and applicable shop standards.
• Perform intermediate grinding and polishing of welds and material to specified finishes.
• Interpret and work from engineering drawings, weld symbols, and bill-of-materials without direct guidance.
• Set up welding equipment, select appropriate wire/filler, and adjust parameters for material thickness and joint configuration.
• Perform fit-up, tacking, and alignment of components prior to final weld.
• Perform dimensional verification using calipers, squares, and measuring tapes; document and correct discrepancies.
• Use material-specific inspection methods to verify surface finish and weld integrity; report non-conformances to QA-QC.
• Operate forklifts, overhead cranes, and man lifts as authorized.
• Identify and correct minor fit-up issues; escalate structural or design concerns to Fabricator III or Production Supervisor.
• Maintain stainless steel surface integrity: minimize cross-contamination from carbon steel tools and abrasives.
• Maintain a clean, organized workstation; store tooling and consumables per shop procedures.
• Wear all required PPE including respiratory protection when grinding or welding stainless steel.
• Follow all OSHA, ASME, and JBF shop safety procedures; report hazards immediately.
• Mentor and assist Fabricator I employees on basic techniques and safety procedures as directed.
• All other duties as assigned.

Marginal (Non-Essential) Functions

The following duties are secondary functions that could be reassigned to another employee if a reasonable accommodation is required:

• Assist with shop layout and material staging for incoming projects.
• Participate in tool and equipment maintenance checks.
• Support shipping and receiving of fabricated assemblies as needed.