工控電子/韌體設計工程師Control Electronics / Firmware Design Engineer【竹南Zhunan/台中Taichung/高雄Kaohsiung】

1.類比訊號分析及電路設計。
2.小信號低雜訊放大線路的設計、模擬、量測及驗證。
3.熟悉OPAMP, Ether CAT, Filter, ADC/DAC, LDO, DC2DC… 規格, 性能特性及應用。
4.電子電路硬體的設計、驗證、失效分析和故障排除
5.訊號雜訊處理經驗(軟體、電子電路、PCB布局、或機構屏蔽…)
6.MCU應用經驗
7.具備電源管理（Power Application）或馬達控制（Motor Control）應用經驗者尤佳。

1.Perform analog signal analysis and circuit design.
2.Design, simulate, measure, and validate low-noise amplification circuits for small-signal applications.
3.Familiar with the specifications, performance characteristics, and applications of operational amplifiers (Op-Amps), EtherCAT, filters, ADC/DAC, LDO regulators, and DC-DC converters.
4.Responsible for electronic circuit and hardware design, verification, failure analysis, and troubleshooting.
5.Experience in signal noise reduction and interference mitigation through software, electronic circuit design, PCB layout, or mechanical shielding.
6.Hands-on experience with microcontroller (MCU) applications.
7.Experience in power management applications or motor control systems is preferred.

工作地點可討論(請在自我推薦欄中說明您偏好之地點)
Work location is negotiable. Please indicate your preferred work location in the self-recommendation section of your application.
台中：台中市西屯區工業區三十七路18號
竹南：苗栗縣竹南鎮群義路69號
高雄：高雄市路竹區路科十路1號