Welder Fitter Fabricators - 2nd SHIFT
Posted
We are looking for flux-cored welders with experience in custom/structural steel fabrication, to perform the following duties:
- Setting up 600 amp wire feed welders
- Experience in the use 100 ton cranes
- Use of cutting and heating torches
- Grinding
- Drilling
- Taping
- Sawing
- Use of an iron worker
- Overhead crane use
- Materials handling
- Ability to work from scaffolding
- Flux-cored welders with experience in custom/structural steel fabrication
- 2nd shift: Mon-Thurs, 2pm to 12:30am; extra $1.50/hour for 2nd shift.
- Candidates should have experience on weld fillets ranging from 1" to 2"; must be able to perform multi-pass welds, as well as gauging and grinding.
- We will accept entry-level welders for 2nd shift (pay range for entry level is $20-$25)
- Technical training and/or experience required
- Hourly wage is dependent on experience and capabilities; please include your wage expectations with your resume; extra $1.50/hour for 2nd shift
- There will be occasional overtime to the 40 hour work week